Motor Cooler for Laotie Ti30 Boyueda GUNAI GN54 & other similar Escooter

If you are pushing your Scoot to the limit then you can notice that motors are pretty hot, actually rear motor can be so hot that you are even not able to touch side shell ( as you can imagine it seriously decrease life span of the motor ). Temperature inside the motor can be even 3x higher then outside shell, so if you mount cooler and temperature drops for even 10C then inside can drops for even 30C.

This cooler is not super efficient due to closed rim design but still push much more air over motor shell to cool it down, compare to simple air flow without cooler.

**It will fit only on Escooter motors like:  Boyueda , Laotie Ti30 , GUNAI GN54 & other ones which got the same motors.

You Have to install washers and spacers in the same order like on this photo

You will receive 1x Cooler , 3x long stainless steel screws , 6x stainless steel washers , 3x nylon spacers 

** Impact filament is printed at temperature around 250C , it’s very hard to print, some imperfections may occur.

**Use it at your own risk**

Here is video how to install cooler